Use a screwdriver to puncture the holes beneath the bottom of the control box. Remove the cover by unscrewing the four screws on the cover. Be aware of the motor cable length before deciding the installation position. Decide the installation position of control box first, it is suggested to be installed near the gate and should be protected from possible damage. TRANSMITTER MEMORIZING AND ERASING PROCESSÄ¡. O SPEED) 2.2.6 SINGLE AND DUAL GATE OPERATION ADJUSTMENT (DIP 8.DS/SET) D SPEED) 2.2.5 OPERATION SPEED ADJUSTMENT OF THE GEAR MOTORS (DIP 7. SW2 DIP SWITCH SETTING 2.2.1 PHOTOCELL ADJUSTMENT (DIP 1.PHOTO1, DIP 2.PHOTO2) 2.2.2 CLOSE DELAY OF DUAL GATE OPERATION ADJUSTMENT (DIP 3.DELAY1, DIP 4.DELAY2) 2.2.3 ELECTRIC LATCH ADJUSTMENT (DIP 5.LATCH) 2.2.4 DECELERATION SPEED ADJUSTMENT OF THE GEAR MOTORS (DIP 6. SLOW) 2.1.2 OVER-CURRENT ADJUSTMENT (DIP 2.OVER C1 & DIP 3.OVER C2) 2.1.3 GATE AUTO-CLOSE ADJUSTMENT (DIP 4.AUTO C1, DIP 5.AUTO C2 & DIP 6.AUTO C3) 2.1.4 PEDESTRIAN MODE ADJUSTMENT (DIP 7.P MODE) 2.1.5 FLASHING LIGHT ADJUSTMENT (DIP 8.LIGHT) CONTROL BOX SETTING SW1 DIP SWITCH SETTING 2.1.1 SLOWDOWN ADJUSTMENT (DIP 1.
0 Comments
Leave a Reply. |